Sallen Key Circuit for Low Pass Chebyshev Filter.
The applet on this page uses 2nd and 3rd order Sallen Key circuits to construct LP Chebyshev Filters with orders 2 to 9.
Even order filters 2, 4, 6, 8 can be constructed from 1, 2,
3, 4 second order sections. Odd order filters 5, 7, 9 can
be constructed from 1 third order and 1, 2, 3 second
The applet calculates normalized and denormalized components
and illustrates the magnitude and phase error introduced when any of the components are out by ± 20%.
The Circuits used are shown above.
Second and third order Circuit and Filter transfer functions
can be written as shown above. Circuit components are calculated by
equating the coefficents of powers of s.
In the applet below, the filter shown is determined by Fn which is
set by scrollbar (0). Fn = 1 to 8 shows filters with orders 2 to 9.
The normalized component values shown are calculated from the
equations above and are shown by the green text on the applet.
The denormalized component values are calculated from the normalized
values, the 3dB frequency set by scrollbars(38, 39 and 40) and
the impedance scaling factor set by scrollbars(41 and 42).
Denormalized component values are shown by the yellow text on the
Scrollbars 11 to 30 are used to show the effect that inaccuracies
in the component values can have on the circuit transfer function.
The green text at the top show which component are affected by
which scrollbar. eg R1 is changed by scrollbar (11) and C1 by
scrollbar(21). The % change from the correct value is shown for each component.
Scrollbars (45 to 48) are used to change the gain of the
error and T/F phase and magnitude.
All resistor values are in ohms and capacitor values are
The passband Ripple is set by scrollbar(2).
The Image below shows an 8th order 1dB passband ripple Chebyshev filter (Fn = 7) implemented
with 4 sections and 4 opamps(8 resistors and
8 capacitors). Normalized
components are shown in green at the top and denormalized
components are shown in yellow at the bottom. In this case,
the 3dB frequency is 1kHz and the Impedance scaling factor
Pink and Cyan plots show the magnitude and phase error
introduced when the capacitor C1 in section 4 is 20%
larger than its correct value. 20% change is shown in the
normalized components at the top but does not affect the
denormalized components at the bottom.
Numerical values of the errors can be seen at the bottom by using scrollbar 43 to move the white line.
Return to main page
Return to page index
COPYRIGHT © 2010 Cuthbert Nyack.